Repeat-failure analysis
Why the same motor, drive or board keeps failing, and what to change.
Advisory
Reliability and spares advisory for servo, drive and PLC equipment
Star Automations turns what it sees on the repair bench into advice: why the same unit keeps failing, whether to repair or replace, which spares to hold and which parts of your installed base are going obsolete. Send a list of units or a failure history and you get written findings. Star Automations is an independent multi-brand repair company and is not an OEM service centre.
01Advisory
Four services, one starting point
Each one starts from the units you already have, and each ends in a written document you can act on.
Repair-or-replace advice
A clear recommendation per unit: repair, exchange, refurbished spare or replacement.
Critical spares list
Which spares are worth holding on the shelf, and in what condition.
Obsolescence audit
Which installed units are discontinued, and the repair, spare or migration route for each.
02Basis
What the advice is based on
Star Automations has repaired servo motors, drives, encoders, PLCs, HMIs and power electronics since 2000. The advice draws on what fails, how it fails and which parts are hard to find.
- Failed units examined at the bench, not only fault codes
- Repair findings: which part failed and what was around it
- Spare availability across new-surplus, refurbished and used stock
- Repair, exchange and migration options kept side by side
03Process
How an advisory job runs
The same five steps apply to all four services.
Send the list
Models, quantities, machines and any fault history, in a sheet or on WhatsApp.
Scope
We confirm what the list covers and what is still missing.
Review
Units and records are reviewed, with bench checks where units are available.
Written findings
A document per service with the reasoning shown, not only the conclusion.
Review call
We walk through the findings and the next actions with your team.
Who is this for?
Maintenance, reliability and stores teams that run servo motors, drives, PLCs and HMIs and want fewer repeat breakdowns and fewer surprises on spares.
Do I need to have used Star Automations for repairs?
No. The advice covers any make, and units from any source can be sent for review.
What do I need to send?
A list of the units with make, model and quantity is enough to start. Fault history, photos and failed units make the findings more specific.
Is Star Automations an OEM service centre?
Star Automations is an independent multi-brand repair company and is not an OEM service centre.
Send a unit list or a failure history.
WhatsApp or call +91 97866 22233, or email info@starautomations.com.