Wireless test rental · Bengaluru
Rent a LitePoint IQxel-M for the days you actually need it.
Conducted Wi-Fi 5, Bluetooth, Zigbee and GNSS checks on a working LitePoint IQxel-M at our Bengaluru facility of about 7,000 sq ft. An operator is on the bench for the session. This is measurement time, not a certificate.
A date is booked only after your chipset matches the licences on this unit.
Three teams book this bench
NPI design house
A board is back from fab and the radio has to be read before the next spin. You need power, EVM and mask numbers this week, not a lab slot next month.
EMS pilot, or a tester down
A pilot build needs conducted data before the line is signed off, or the line tester is out and boards are waiting.
OEM before an accredited lab
A pre-check, so the accredited lab is not the first place anyone measured the unit. What is found here costs less than a failed lab run.
A bench day here, or a supervised rental on your line
There is no bare day rate. Each booking is quoted against the chipset, the bands and the fixture.
Bench day at Bengaluru · recommended
The instrument stays here. You bring the board, the fixture and the cables, or courier them ahead. Our operator runs the session with you, and you leave with the data.
Supervised rental, Bengaluru area
The unit goes to your line with our operator, who stays with it for the session. A deposit and a signed condition note are agreed before it leaves the facility.
The instrument is not handed over for unsupervised use, and it does not travel outside the Bengaluru area.
Conducted readings, recorded against the path loss
Path loss for the cable and fixture is measured first and written down, so the numbers mean something afterwards.
ESP32-class modules, common Realtek Wi-Fi 5 parts and Nordic-class BLE can usually start on the day. Anything else needs a setup day before the measurement day.
- Path loss, cable and fixture
- TX power
- EVM
- Spectral mask
- Frequency error
- RX sensitivity and PER, where the DUT reports it
LitePoint IQxel-M, conducted and non-signalling
| Item | Detail |
|---|---|
| Instrument | LitePoint IQxel-M, working unit |
| Method | Conducted, non-signalling |
| RF range | About 60 MHz to 6 GHz |
| DUTs per session | Up to 4, where the ports and the fixture allow |
| Wi-Fi | 802.11 a/b/g/n/ac |
| Bluetooth | Classic and LE |
| Other standards | Zigbee, Z-Wave, Wi-SUN |
| GNSS | Receive: GPS, GLONASS, BeiDou |
| Measurements | TX power, EVM, spectral mask, frequency error, RX sensitivity and PER |
Every standard above is subject to the licences active on this unit. Send the chipset and the bands first, and we confirm what this unit can read before anything is booked.
What this is not
Read this before you ask for a date. If your requirement is on this list, an accredited lab is the right place, and we will say so.
The unit’s service and verification records are shared in writing before a booking is confirmed.
- Not Wi-Fi 6, Wi-Fi 6E or Wi-Fi 7, and not the 6 GHz band
- Not WPC, TEC, CE or FCC certification, and no certificate is issued
- Not Wi-Fi Alliance certification
- Not radiated test, and not SAR
- No chamber. Measurement is conducted, through cables and a fixture
- Not an unsupervised takeaway rental
Four steps, starting with the chipset
Send the details
Chipset, bands, whether you have a fixture, and the dates you want. WhatsApp +91 97866 22233.
We confirm the options
We check the chipset and bands against the licences on this unit, and say what can be read and what cannot.
Samples, or a line window
You send the boards for a bench day here, or we agree a window and our operator brings the unit to your Bengaluru-area line.
You get the data
CSV and plots, with the path loss recorded against them. Not a certificate.
Do you give a WPC or CE report?
No. This is conducted measurement for your own engineering use, and no certificate is issued. For WPC, TEC, CE or FCC the unit goes to an accredited lab, and these readings are what you take into that visit.
Do you test Wi-Fi 6, 6E or 7?
No. This unit covers 802.11 a/b/g/n/ac, Bluetooth Classic and LE, Zigbee, Z-Wave, Wi-SUN and GNSS receive, subject to the licences on it. The 6 GHz band is not covered.
Can we run the instrument ourselves?
No. Our operator is on the bench for the session, and the unit is not handed over for unsupervised use.
Is the tester available in Chennai or Puducherry?
No. This instrument is at our Bengaluru facility, and supervised rental stays within the Bengaluru area.
What do we send with the board?
The DUT, the pigtail or connector for a conducted connection, the supply, a way to put the radio into test mode, and the limit you are measuring against if you have one.
Send the chipset and the dates.
We confirm what this unit can read before anything is booked. WhatsApp or call +91 97866 22233, or email info@starautomations.com.