Alarm guide · Siemens · Updated October 2026
Siemens Sinamics F30001 alarm: power unit overcurrent
Siemens Sinamics F30001 is a power unit overcurrent fault. Look for a short in the motor or cable, wrong motor data, or a drive fault.
By Suresh Sankaran, founder of Star Automations, servo motor repair since 1998.
What the alarm means
The drive measured current above its limit and tripped. Alarm numbers and wording can differ between series, so confirm with the manual for your unit.
Common causes
- Motor winding short or earth fault
- Motor cable fault
- Wrong motor data or ramp too short
- Power module fault in the drive
- Moisture in the motor
Safe first checks
General guidance only. Follow the drive manual and your site's electrical safety rules. Power off, and let the DC bus discharge, before touching connectors.
- Note the exact alarm code and when it appears: at power-up, at start, or under load.
- Power off and turn the shaft by hand if safe: it should turn smoothly.
- Check the motor cable, encoder cable and connectors for damage and loose contacts.
- Check what changed recently: load, speed, settings, cables or a replaced part.
When to send it for repair
Disconnect the motor and test insulation and winding.
We test every motor on our Universal Servo Motor Repair Equipment, which reads and aligns the feedback and runs the motor under load without the original drive.
See Siemens servo motor repair, Siemens encoder repair and Siemens servo drive repair.
Questions
How do I split motor from drive?
Disconnect the motor cable and test the motor, then the cable, then run the drive without the motor.
How long does repair take?
Emergency repair is done the same day where the fault and parts allow, urgent in 3 working days and standard in 7 working days, counted from when the unit reaches our bench and the quote is approved. Every unit returns with a printed test report.
Can I get an exchange unit?
If we hold a matching unit, Servo Swap ships a tested exchange unit while yours is repaired. Mark "line down" on the request form and add the part number.
Related: servo encoder alarms
Brand names identify the units we repair. Star Automations is an independent multi-brand repair company and is not an OEM service centre.