Alarm guide · Siemens · Updated October 2026
Siemens Sinamics F07011 alarm: motor overtemperature
Siemens Sinamics F07011 means the motor is too hot. Check the load, cooling and the temperature sensor.
By Suresh Sankaran, founder of Star Automations, servo motor repair since 1998.
What the alarm means
The temperature sensor in the motor crossed its limit. Alarm numbers and wording can differ between series, so confirm with the manual for your unit.
Common causes
- Load or duty too high
- Poor cooling or dirty motor
- Sensor wiring fault
- Bearing friction
- Winding fault
Safe first checks
General guidance only. Follow the drive manual and your site's electrical safety rules. Power off, and let the DC bus discharge, before touching connectors.
- Note the exact alarm code and when it appears: at power-up, at start, or under load.
- Power off and turn the shaft by hand if safe: it should turn smoothly.
- Check the motor cable, encoder cable and connectors for damage and loose contacts.
- Check what changed recently: load, speed, settings, cables or a replaced part.
When to send it for repair
A motor that runs hot on a normal load should be inspected.
We test every motor on our Universal Servo Motor Repair Equipment, which reads and aligns the feedback and runs the motor under load without the original drive.
See Siemens servo motor repair, Siemens encoder repair and Siemens servo drive repair.
Questions
Could it be the sensor?
Yes, a faulty sensor or cable gives the same message.
How long does repair take?
Emergency repair is done the same day where the fault and parts allow, urgent in 3 working days and standard in 7 working days, counted from when the unit reaches our bench and the quote is approved. Every unit returns with a printed test report.
Can I get an exchange unit?
If we hold a matching unit, Servo Swap ships a tested exchange unit while yours is repaired. Mark "line down" on the request form and add the part number.
Related: servo encoder alarms
Brand names identify the units we repair. Star Automations is an independent multi-brand repair company and is not an OEM service centre.