Specialist repair · Load cell and weighing electronics
Load cell and weighing electronics repair in India
Star Automations repairs weighing indicators, load cell amplifiers, transmitters and weighing system electronics for plants. Send the label photo and the symptom, and we confirm whether the unit is repairable before you ship it. Repaired units are tested and returned with a test report.
What we repair
Star Automations repairs weighing indicators, load cell amplifiers, transmitters and weighing system electronics for plants.
Units come to our benches in Chennai, Puducherry and Bengaluru by courier or transport. We confirm repairability from the label photo before you ship.
- Indicators, amplifiers and transmitters
- Board-level diagnosis
- Test report with the repaired unit
- Calibration remains your weighing authority’s task
Brands and equipment we repair
Mettler Toledo
indicators and terminals
Minebea and Sartorius
indicators and controllers
Avery Weigh-Tronix
indicators
Flintec and HBM
amplifiers and transmitters
Siemens (SIWAREX)
weighing modules
Other makers
weighing indicators and junction electronics
Not listed? Send the label photo. We repair other makes and obsolete models where circuits and parts allow.
Common faults and what to check first
Display unstable or drifting
Check the cable, junction box and load cell first. Moisture in the junction box is a common cause.
No display or no response
Supply or board faults in the indicator. Send the label photo and the symptom.
Overload or error message
The cause may be the load cell, the cable or the amplifier. Note the message shown.
Weighing output not reaching the PLC
Output or communication board faults. Tell us the interface type.
How it works
Photo
Send the label photo and the fault.
Check
We confirm repairability and a quote.
Ship
The unit comes to our bench.
Repair
Board-level repair and test.
Return
Unit and test report go back to you.
Free repairability check: what to send
Send these details and we tell you whether the unit is repairable before you ship anything.
- Label photo showing model and serial number
- Symptom (drift, no display, error message)
- Interface type and what it connects to
- Number and capacity of load cells connected
- Whether the junction box or cable was wet or damaged
Send the label photo
Name, contact and a photo of the label is enough to start.
Message received
Our team replies by email or WhatsApp with the next step. For anything urgent, WhatsApp +91 97866 22233.
Frequently asked questions
Do you repair weighing indicators and load cell amplifiers?
Yes. We repair indicators, amplifiers, transmitters and weighing modules at board level. Send the label photo and the symptom and we confirm repairability.
Do you repair the load cell itself?
This page covers weighing electronics. For a damaged load cell, tell us the model and the damage and we advise whether it is something we can help with.
Do I need to recalibrate after repair?
Usually yes. Calibration and any legal-metrology approval remain the job of your weighing service provider or authority.
How do I find out if the problem is the indicator or the load cell?
Check cables and the junction box first, then test with a known good indicator or cell. Send us the details if you want help narrowing it down.
Can you repair an obsolete indicator?
Often, at component level where circuits and parts allow. Send the label photo.
What should I send?
The indicator or amplifier, the label photo, the symptom and the interface type. Use the checklist on this page.
How long does repair take?
Timing depends on the fault and parts. Send the label photo first and we confirm repairability and timing before you ship.
Related: Servo motor repair · Encoder repair · Obsolete spares · Parts request