Alarm guide · Mitsubishi · Updated October 2026
Mitsubishi AL.33 alarm: overvoltage
Mitsubishi AL.33 is an overvoltage alarm: the main circuit bus voltage went above the allowed level, most often from regenerative energy or a high supply.
By Suresh Sankaran, founder of Star Automations, servo motor repair since 1998.
What the alarm means
The amplifier detected too high a DC bus voltage and stopped to protect itself. Alarm numbers and wording can differ between series, so confirm with the manual for your unit.
Common causes
- Regenerative resistor missing, open or too small
- Fast deceleration of a heavy load
- Supply voltage above the rated range
- Regenerative circuit fault in the amplifier
- Wrong regenerative parameter
Safe first checks
General guidance only. Follow the drive manual and your site's electrical safety rules. Power off, and let the DC bus discharge, before touching connectors.
- Note the exact alarm code and when it appears: at power-up, at start, or under load.
- Power off and turn the shaft by hand if safe: it should turn smoothly.
- Check the motor cable, encoder cable and connectors for damage and loose contacts.
- Check what changed recently: load, speed, settings, cables or a replaced part.
When to send it for repair
The motor itself is not usually the cause. Check the regenerative circuit and the supply, then the load inertia.
We test every motor on our Universal Servo Motor Repair Equipment, which reads and aligns the feedback and runs the motor under load without the original drive.
See Mitsubishi servo motor repair, Mitsubishi encoder repair and Mitsubishi servo drive repair.
Questions
How is AL.33 different from AL.30?
AL.30 points to the regenerative circuit. AL.33 is the resulting high bus voltage. They often appear together.
How long does repair take?
Emergency repair is done the same day where the fault and parts allow, urgent in 3 working days and standard in 7 working days, counted from when the unit reaches our bench and the quote is approved. Every unit returns with a printed test report.
Can I get an exchange unit?
If we hold a matching unit, Servo Swap ships a tested exchange unit while yours is repaired. Mark "line down" on the request form and add the part number.
Related: AL.25 · AL.50 · AL.16 and AL.20
Brand names identify the units we repair. Star Automations is an independent multi-brand repair company and is not an OEM service centre.